To ensure proper installation and receive useful tips to expedite installation read the follow guides below.
Remove Debris from Drain Pan Using Wet/Dry Vacuum
- Remove threaded cap and allow excess water to drain.
- Attach connector end of vacuum hose into suction port of wet/dry vacuum.
- Attach remaining end of vacuum hose into Angle Tool or Straight Tool according to the specifications of your application.
- Insert tool into A/C Easy Tee. If using Angle Tool, be sure to align arrow with center of drain line.
- Apply enough pressure to keep tool seated.
- Energize vacuum to allow standing water and debris to be pulled into wet/dry vacuum.
- Remove threaded cap and allow excess water to drain
- Attach hose nozzle into Angle Tool or Straight Tool according to the specifications of your application.
- Insert tool into A/C Easy Tee. If using Angle Tool, be sure to align arrow with center of drain line.
- Apply enough pressure to keep tool seated while flushing.
- Using caution, slowly pressurize drain line. You should feel some resistance followed by a free flow of water.
- Allow water to flow until debris is flushed through the drain line.
- Remove threaded cap and allow excess water to drain.
- Thread Compressed Gas Adapter Tool into Angle Tool or Straight Tool according to the specifications of your application.
- Attach compressed gas source onto 1/4” male flare fitting on Compressed Gas Adapter Tool.
- Regulate compressed gas at 30psi maximum.
- Insert tool into A/C Easy Tee. If using Angle Tool, be sure to align arrow with center of drain line.
- Apply enough pressure to keep tool seated while flushing.
- Using caution, slowly pressurize drain line. You should feel some resistance followed by a free flow of compressed gas.
- Allow compressed gas to flow until debris is flushed through the drain line.
Clear Drain Using Water Hose
Clear Drain Using Compressed Gas
Recommended Locations for the A/C Easy Tee
The A/C Easy Tee can be installed in either location or both locations.